PCB Board Rapid Tester
Measured values can be set with upper and lower limits; alarms may be configured for cases outside or within the specified range. A green “Test OK” indicator confirms successful testing, and a pure copper plum-blossom head probe with low resistance and a large contact area is used to prevent poor contact. Equipment operating procedure:
Measured values can be set with upper and lower limits; alarms may be configured for cases outside or within the specified range. A green “Test OK” indicator confirms successful testing, and a pure copper plum-blossom head probe with low resistance and a large contact area is used to prevent poor contact. Equipment operating procedure:
The measured values can be assigned corresponding upper and lower limits. Alarms can be configured to trigger when readings fall outside the specified range or when they remain within it. A “Test OK” indicator with a green light confirms successful testing. A pure copper plum-blossom head probe is used, providing low resistance and a wide contact area to help prevent poor contact. Equipment operating procedure:
Switch on the device and set the parameters.
Place the PCB into the fixture.
Manually press down the probe.
The device performs automatic testing; an “NG” or “OK” prompt is displayed.
Remove the product and proceed to the next cycle.
